Operation Manual

- 16 -
4.3 Accessories Installation
Anti-vibration bases
1. Take out 4 Anti-vibration bases
2. Put them one by one on the
bottom of machine like the picture.
Draining jet
1. Install the draining jet under the
bottom panel
2. Connect with a water pipe to
drain out the water.
Note: Lift the heat pump to install
the jet. Never overturn the heat
pump, it could damage the
compressor.
Water Inlet & outlet junction
1. Install the two joints like the
picture shows
2. Screw them onto the water Inlet
& outlet junction
Cable wiring
1. Open the wiring block box
(marked red) on the side of
machine
2. Fix the other side on joints inside
the electric box.
Water pump wiring (Dry contact)
1. Open the wiring block box
(marked red) on the side of
machine
2. Fix the other side on joints inside
the electric box.
4. Accessories and options