Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

2. Open the Front Cover (hinged at bottom).

Open the three Latches [A].

3. Remove the new Tank(s) from packaging.

4. Slide the new Tanks (label up) into their

appropriate color slots [B].

INSTALLATION TIP – Make sure the

Tanks seat properly. Insert the Tank

into the appropriate Ink Station, then

pull the Tank back about an inch and

push forward firmly to insure that the

Ink Nozzles penetrate the seals on the

Tanks.

5. Turn the Printer ON by pressing the Main Power

Switch on the Rear Panel, then pressing Control Panel

Power Button. Watch the Toolbox screen on your

computer; you will see the ink colors fill in as the Tanks

are installed. If the ink color does not fill in after a few

seconds, reinstall the Tank.

6. Close the three Latches. Close the Front Cover.

WARNING

The ink in the Ink Tanks may be harmful if

swallowed. Keep new and used Tanks out

of reach of children. Discard empty tanks

immediately.