Troubleshooting guide

SECTION 4
MAINTENANCE
44
3. Carefully slide the Service Station out of the Service
Station port. NOTE: DO NOT pull the Service
Station all the way out until you disconnect the
Ribbon Cable.
USEFUL TIP: Place an absorbent towel under the
Service Station before you remove it to catch any
drips or leaks.
4. Disconnect the Ribbon Cable. Slide the Latch open
on the Service Station Circuit Board to release the
Ribbon Cable. Remove the Service Station.
5. Carefully unwrap the new Service Station.
NOTE: Loose parts may fall out. Keep
the roller side facing up when removing
packaging.
CAUTION
MAKE SURE THE LATCHES ON
THE WIPER ROLLER ARE FULLY
LOCKED BEFORE INSTALLING
THE SERVICE STATION.