Owner`s manual

2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the remote will emit 4 quick beeps and

the LCD screen will indicate which switch (5-flashes) tripped the alarm.

3. If the system was triggered so many times that NPC is active the remote will emit the above

notifications with 5 beeps instead of 4.

DISARMING WITHOUT A TRANSMITTER

This feature allows you to disarm the security system without the remote transmitter should it be

lost or damaged. In order to disarm the system without a remote transmitter, you must have the

vehicle’s ignition key and know where the Valet button is located. Be sure to check with the

installer for the location and the number of presses of the Valet button required to disarm the

system.

To disarm the security system, turn the ignition to

the ON position. Press the Valet button the preset

number of times (one to five times) within 15 seconds.

After five seconds the system will disarm. If the system

does not disarm, you may have waited too long; turn

the ignition off and on and try again.

Location of Valet Button

Number of Pulses

IMPORTANT! The unit can be programmed to respond to one

to five pulses of the Valet button for the disarm function.

Be sure to check with the installer for the desired programming.

The LCD remote will indicate disarm notification with 4 quick beeps and 5 flashes of the

and

triggered zone icons.

DOME LIGHT CONTROL

Security only

The dome light activates for 30-seconds after the system is disarmed.

Ignition controlled

The dome light activates for 30-seconds after the ignition is turned Off.

Door controlled

The dome light activates for 30-seconds after the system sees a door has closed. (If door was held

open for longer than 3 minutes the dome light will not illuminate.)

Full

The dome light activates for 30-seconds after seeing door closure, ignition, or security disarm.