Owner`s manual

NOTE: When the shock sensor adjustment mode is exited, the bar

indicator will indicate continuously. For example if level 15 was being

set (bars 1 through 7 indicating continuously, and bar 8 flashing), upon

exiting adjustment mode bars 1 through 8 will indicate continuously.

Bar No.1 Bar No.10

Sensor level setting Shown at mid-point

2. Decrease Sensitivity—Press and release the

button to decrease shock sensor

sensitivity by one step. The siren will beep 1-time for each step decreased in adjustment

(1 vibrate if programmed). The shock sensor adjustment reaches minimum sensitivity

(sensor Off ) when the indicator bar is empty .

3. Testing Sensor—Use the heel of the palm of your hand to strike the door pillar of the car

after any increase or decrease in adjustment. The siren will chirp once if the impact was

great enough to generate a full trigger. Pre-warn level is set automatically. When

desired setting is reached, sensor adjustment mode can be exited.

EXIT SHOCK SENSOR ADJUSTMENT MODE:

The adjustment mode will be exited if:

 No input from transmitter for 15-seconds.

 No input from sensitivity testing for 15-seconds.

 The ignition is turned On.

 The Valet button is pressed.

The siren and LCD remote will emit 1 long beep and the LED will extinguish when shock

adjustment mode is exited.

RESET SHOCK SENSOR TO DEFAULT SETTING:

The shock sensor can be restored to a default setting of 10 to facilitate re-adjustment at any time

while in adjustment mode.

1. Simultaneously press the

and buttons.

2. The LCD remote will emit 3 quick beeps to indicate the sensor has been reset to level 10

(mid-range).

3. The system returns to shock sensor adjustment mode for further adjustment, if

required.