Owner`s manual

QUICK REFERENCE GUIDE

To arm using your remote

 You can activate, or arm, the system by pressing

on your remote for one second. When

the system arms, you will hear a short siren sound, or chirp, and the parking lights will flash

once. If the vehicle’s power door locks have been connected to the system, the doors will

lock.

To disarm using your remote

 To disarm the system, press

. You will hear two chirps, and the parking lights will flash

twice. If power locks are connected to the system, the doors will unlock. If the siren chirps

either four or five times when disarming, see Diagnostics section. This is called Tamper Alert.

Arming while driving

 Press

on your remote for two second while the vehicle is running. The system will chirp

once and then once more to indicate that the ignition is on.

Disarming without a remote

 Turn on the ignition. Press and release the Valet

button the programmed number of times

within 15 seconds. After three seconds, the system will disarm. If it does not, you may have

waited too long. Turn the ignition off and on and try again.

To enter or exit Valet

Mode

 Turn ignition to RUN position, then turn to OFF position. Press and release the Valet

button

within 10 seconds. The in-vehicle status LED will light solid if you are entering Valet

Mode,

and it will go out if you are exiting Valet

Mode.

Location of Valet Button

Number of Pulses

To activate Panic Mode

 Press and hold

down for approximately two seconds or press

down for

approximately five seconds.

To exit Panic Mode

 Press and hold

down for approximately one seconds.

To activate Silent Mode™

 Press

briefly before arming or disarming, and the confirmation chirp(s) will be eliminated

for that one operation only.