Owner`s manual

Important information

Congratulations on the purchase of your state-of-the-art vehicle security system. This system has

been designed to provide years of trouble-free operation. Due to the complexity of this system, it

must be installed by an authorized dealer only. Installation of this product by anyone other than

an authorized dealer voids the warranty. This owner’s guide should help you to get the most out

of your system. Please take the time to read it prior to using the system.

SYSTEM MAINTENANCE

This system needs no specific maintenance beyond remote controls battery

replacement.

The 4-button remote is powered by a 1.5V AAA battery.

FULL

CHARGE

NEED

REPLACEMENT

EMPTY

The Battery Level indicator has four level indicators that serve as a visual

indication of battery charge. When the battery reaches a low charge level

that requires replacement, the remote control will generate a single

notification chirp, and the Battery Level indicator will flash continuously.

Battery Replacement

Gently pull the end of the battery door away from the top of the remote control then slide the

door up to expose the battery and remove the expired battery. Place the new battery into the

remote control observing the correct polarity. When power is returned the remote control will

display all icons in the LCD and generate all beeper tones once. Press any button on the remote to

terminate the beeper tone review.

The 3-button remote is powered by a small, lightweight 3-volt lithium battery (CR2032) that will

last approximately one year under normal use. When the battery begins to weaken, operating

range will be reduced and the LED on the remote will dim.

Battery replacement

Remove the screw on the back of the remote, gently open the casing to expose the battery and

remove the expired battery. Place the new battery into the remote control observing the correct

polarity.

FCC/ID NOTICE

Directed Electronics, Inc

This device complies with Part 15 of FCC rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2)

This device must accept any interference received,

including interference that may cause undesirable

operation. Changes or modifications not expressly

approved by the party responsible for compliance could

void the user's authority to operate this device.

Tested to comply

with FCC standards