Owner`s manual

Remote operation

The system operates at 434 MHz. The high frequency combined with Binary Data communication

achieves superior range with two way communication.

SYSTEM SIGNAL PAGING FEATURES

A page is the signal the control module sends to the remote control as confirmation of receipt of

a command or alarm system status. When the remote control receives a page it will generate a

page notification to the user (notifications are audible beeps and-or vibration) and the LCD Icons

will display the current system status.

COMMAND PAGE

When a command (arm/disarm, or auxiliary channel) from the remote control is sent and

received, the system will send a command page back to confirm receipt.

ALARM PAGE

If the alarm system is triggered while armed, an Alarm Page will be sent to the remote control.

When the remote receives an Alarm Page, the LCD icons will display the alarm system status

information and the remote control will generate beeps and-or vibration. An Alarm Page alert is a

series of 5 groups of 4 rapid beeps (shock, trunk, door, ignition, or hood trigger) and the LCD icon

that caused the alarm will display. This will repeat every 60 seconds to alert the user that the

alarm system was triggered and will continue until the alarm page is cleared.

PAGE RECOGNITION (ACKNOWLEDGEMENT)

To clear a page alert/notification, quickly press any button on the remote control. This can be

performed at any time during or after the page notification has occurred. The remote control will

not send a command to the system at this time; it will only clear future repeats of the page

notification. The next time a button is pressed on the remote control it will send a command to

the system.

OUT OF RANGE NOTIFICATION

If a command is issued from the remote, but the remote is set to the incorrect vehicle or is

beyond the range of the vehicle to receive the command, the remote responds with 3 set of 2

quick beeps and the icon

will flash 3-times.