Owner`s manual

Programming LCD remote

TO ENTER PROGRAMMING MODE

Press and hold the

button until one long beep is heard. Programming mode to customize the

remote’s response is now entered.

NOTE: If no buttons are pressed within 5-seconds,

programming mode will exit with 2-beeps.

BEEPS/VIBRATION ON/OFF

Press to select beeps/vibration On/Off. Beeps alone, or vibration alone, or beeps and

vibration, or no beeps or vibration can be selected. Refer to the table below for these settings.

Beep/Vibrate settings Programming response Icon display*

Beeps only (default) 1-beep Siren icon On

Vibrate only 1-vibrate Vibrate icon On

Beep & Vibrate 1-beep and 1-vibrate Vibrate and siren icon On

No Beep and No Vibrate 1 long beep Vibrate and siren icons Off

*NOTE: This is icon display during programming..

ILLUMINATION ON/OFF

Press to select LCD backlight illumination On/Off.

The LCD backlight will illuminate when a remote

button is pressed, or a alarm status page is received.

LCD Backlight settings Programming response

1-beep, backlight ON

OFF

2-beeps, backlight OFF