User's Manual
Table Of Contents
- 1 User Information
- 2 Important Safety Instructions
- 2.1 Safety and Precautions
- 2.2 Regulatory
- 2.2.1 USA – FCC Supplier Declaration of Conformity Product Identification and Responsible Party
- 2.2.1.1 Information to User
- 2.2.1.2 RF Exposure Statement
- 2.2.2 Canada – ISED Compliance Information
- 2.2.2.1 RF Exposure Statement
- 2.2.3 European Union (EU) Compliance Information
- 2.2.3.1 Radio Equipment Directive
- 2.2.3.2 RF Exposure Statement
- 2.2.3.3 WEEE
- 2.2.3.4 RoHS
- 2.2.3.5 REACH
- 2.3 Battery Safety
- 3 Introduction
- 4 Powering Up
- 5 Connecting to Sierra
- 6 Connecting using Aruba’s Web-based GUI
- 7 WLAN Setup
- 8 User Interface
- 9 Performance Data
- 10 Technical Data
- 11 Reliability and Maintainability
- 12 Support and Service
Page | 10 Revision Date April 30, 2020 || Document Number UM-E71-314 || Rev B
astronics.com
Some airlines may permit the use of cellular phones while the aircraft is on the ground and the door is
open. The cellular transceiver module may be used normally at this time.
2.2.1.2 RF Exposure Statement
The device shall be used in such a manner that the potential for human contact during normal operation
is minimized. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and your body. This device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or transmitter.
2.2.2 Canada – ISED Compliance Information
This device complies with the Class B limits for radio noise emissions as set out in the interference-
causing equipment standard entitled “Digital Apparatus,” CAN ICES-3(B)/NMB-3(B).
This device complies with ISED license-exempt RSS-GEN and RSS-247. Operation is subject to the
following two conditions: (1) this device may not cause interference and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme à la norme ISED RSS-GEN et RSS-247. Son fonctionnement est soumis
aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil
doit accepter toute interférence, y compris les interférences pouvant entraîner un fonctionnement
indésirable de l'appareil.
Under Industry Canada regulations, when operated in 5150 to 5250 MHz frequency range, this device
is restricted to indoor use to reduce the potential for harmful interference with co-channel Mobile
Satellite Systems. Users are advised that high power radars are allocated as primary users (i.e. priority
users) of the bands 5250-5350 MHz and 5650-5850MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
Conformément aux réglementations d’Industrie Canada, en cas d'utilisation dans la plage de
fréquences de 5150 à 5250 MHz, cet appareil doit uniquement être utilisé en intérieur afin de réduire
les risques d'interférence avec les systèmes satellites mobiles partageant le même canal. Les
utilisateurs êtes avisés que les utilisateurs de radars de haute puissance sont désignés utilisateurs
principaux (c.-à-d., qu'ils ont la priorité) pour les bandes 5250-5350 MHz et 5650-5850 MHz et que
ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.