User's Manual
Table Of Contents
- 1 User Information
- 2 Important Safety Instructions
- 2.1 Safety and Precautions
- 2.2 Regulatory
- 2.2.1 USA – FCC Supplier Declaration of Conformity Product Identification and Responsible Party
- 2.2.1.1 Information to User
- 2.2.1.2 RF Exposure Statement
- 2.2.2 Canada – ISED Compliance Information
- 2.2.2.1 RF Exposure Statement
- 2.2.3 European Union (EU) Compliance Information
- 2.2.3.1 Radio Equipment Directive
- 2.2.3.2 RF Exposure Statement
- 2.2.3.3 WEEE
- 2.2.3.4 RoHS
- 2.2.3.5 REACH
- 2.3 Battery Safety
- 3 Introduction
- 4 Powering Up
- 5 Connecting to Sierra
- 6 Connecting using Aruba’s Web-based GUI
- 7 WLAN Setup
- 8 User Interface
- 9 Performance Data
- 10 Technical Data
- 11 Reliability and Maintainability
- 12 Support and Service
Page | 20 Revision Date April 30, 2020 || Document Number UM-E71-314 || Rev B
astronics.com
5 Connecting to Sierra
5.1 Terminal Communication Settings
The integrated USB to UART provides console access via the USB-C port that is located behind the
battery door as shown in Figure 5-1. There is also an internal console for the cell modem, when
enabled. Use these settings to connect to the consoles:
Figure 5-1: USB-C connection
Use these settings to connect to the consoles:
Table 5-1: Com Port Settings
Port
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
CPU
115200
8 bit
none
1 bit
none
WAP
9600
8 bit
none
1 bit
none
Cell Modem
9600
8 bit
none
1 bit
none