User's Manual
Table Of Contents
- 1 User Information
- 2 Important Safety Instructions
- 2.1 Safety and Precautions
- 2.2 Regulatory
- 2.2.1 USA – FCC Supplier Declaration of Conformity Product Identification and Responsible Party
- 2.2.1.1 Information to User
- 2.2.1.2 RF Exposure Statement
- 2.2.2 Canada – ISED Compliance Information
- 2.2.2.1 RF Exposure Statement
- 2.2.3 European Union (EU) Compliance Information
- 2.2.3.1 Radio Equipment Directive
- 2.2.3.2 RF Exposure Statement
- 2.2.3.3 WEEE
- 2.2.3.4 RoHS
- 2.2.3.5 REACH
- 2.3 Battery Safety
- 3 Introduction
- 4 Powering Up
- 5 Connecting to Sierra
- 6 Connecting using Aruba’s Web-based GUI
- 7 WLAN Setup
- 8 User Interface
- 9 Performance Data
- 10 Technical Data
- 11 Reliability and Maintainability
- 12 Support and Service
Page | 30 Revision Date April 30, 2020 || Document Number UM-E71-314 || Rev B
astronics.com
7 WLAN Setup
There are four steps to creating an SSID:
1. Select the type of SSID you want to create. The Employee and Voice selections will lead you to
802.1X and PSK authentication. The Guest option will lead you to Captive Portal authentication.
2. Configure the Vlan and client IP assignment.
3. The security stage depends on your wireless LAN setting selections. Enterprise will give you 802.1x
selections, personal will give you PSK or WEP selections. If you select guest you will receive
captive portal options.
4. The last stage is the settings for the firewall with the user rights.
These stages are shown below in Figure 7-1.
Figure 7-1: The Four Stages to Creating an SSID