User's Manual
Table Of Contents
- 1 User Information
- 2 Important Safety Instructions
- 2.1 Safety and Precautions
- 2.2 Regulatory
- 2.2.1 USA – FCC Supplier Declaration of Conformity Product Identification and Responsible Party
- 2.2.1.1 Information to User
- 2.2.1.2 RF Exposure Statement
- 2.2.2 Canada – ISED Compliance Information
- 2.2.2.1 RF Exposure Statement
- 2.2.3 European Union (EU) Compliance Information
- 2.2.3.1 Radio Equipment Directive
- 2.2.3.2 RF Exposure Statement
- 2.2.3.3 WEEE
- 2.2.3.4 RoHS
- 2.2.3.5 REACH
- 2.3 Battery Safety
- 3 Introduction
- 4 Powering Up
- 5 Connecting to Sierra
- 6 Connecting using Aruba’s Web-based GUI
- 7 WLAN Setup
- 8 User Interface
- 9 Performance Data
- 10 Technical Data
- 11 Reliability and Maintainability
- 12 Support and Service
Page | 31 Revision Date April 30, 2020 || Document Number UM-E71-314 || Rev B
astronics.com
Step 1
You create SSIDs using the WLAN Wizard. You launch the WLAN Wizard by selecting New from the
Networks section on the main GUI page. This will bring up the WLAN Settings tab of the New WLAN dialog
box. The WLAN Settings tab is where you select the type of SSID you want to create and name the SSID,
as shown below in Figure 7-2.
Figure 7-2: The WLAN Settings Tab of the New WLAN Dialog Box