User's Manual
Table Of Contents
- 1 User Information
- 2 Important Safety Instructions
- 2.1 Safety and Precautions
- 2.2 Regulatory
- 2.2.1 USA – FCC Supplier Declaration of Conformity Product Identification and Responsible Party
- 2.2.1.1 Information to User
- 2.2.1.2 RF Exposure Statement
- 2.2.2 Canada – ISED Compliance Information
- 2.2.2.1 RF Exposure Statement
- 2.2.3 European Union (EU) Compliance Information
- 2.2.3.1 Radio Equipment Directive
- 2.2.3.2 RF Exposure Statement
- 2.2.3.3 WEEE
- 2.2.3.4 RoHS
- 2.2.3.5 REACH
- 2.3 Battery Safety
- 3 Introduction
- 4 Powering Up
- 5 Connecting to Sierra
- 6 Connecting using Aruba’s Web-based GUI
- 7 WLAN Setup
- 8 User Interface
- 9 Performance Data
- 10 Technical Data
- 11 Reliability and Maintainability
- 12 Support and Service
Page | 33 Revision Date April 30, 2020 || Document Number UM-E71-314 || Rev B
astronics.com
Network Assigned
The client will associate and authenticate to the access point. The access points will act as a bridge and
pass the traffic without modifying the original payload. DHCP will be provided by the DHCP server on the
LAN. The APs will bridge the client traffic onto the wire without manipulating or modifying the packets.
• The AP will bridge the client traffic onto the wire.
• The AP turns the wireless frame into an Ethernet frame.
Step 3
The Security tab is where you set the security level. There are three levels; Open, Personal, and Enterprise.
Selecting the Enterprise level allows you to configure an external RADIUS authentication server, as shown
below in Figure 7-4.
Figure 7-4: Configuring an External RADIUS Server