User's Manual

Page 4 of 10
Installation and Commissioning
The OccupEye system is professionally installed and commissioned ready for use.
The user can recommission the OccupEye system using the OccupEye Interface
software.
To commission a new OccupEye sensor run the OccupEye Interface software, select
the required OccupEye host and click the [Auto Commission] button. If required, load
settings from a file or change the sensor address number in field next to the [Auto
Commission] button. Insert batteries into the sensor. When the field changes from
red to amber to green the sensor has commissioned successfully on the selected
OccupEye host. The sensor address number increments ready for the next sensor.
Click the [Auto Commission] button again to finish.