User's Manual

29
To enable WPS on your wireless network:
1. From the navigation panel, go to Advanced Settings >
Wireless > WPS tab.
2. In the Enable WPS field, move the slider to ON.
3. WPS uses 2.4GHz and 5GHz radio concurrently.
4. You can use any of the following WPS methods for wireless
connection pairing:
• PBC (Push Button Configuration) Mode:
 • HardwarePBContherouter:PressthephysicalWPS
button on wireless router, and then press WPS button on
wireless client for three (3) minutes.
 • SoftwarePBContherouter:Tick<Pushbutton>onWPS
Method field, click Start, and then press the WPS button
on the wireless client for three (3) minutes.
• PIN Code Mode:
 • Pairingfromthewirelessclient:PresstheWPSbuttonon
the wireless router, and then perform WPS connection
process in PIN code mode and enter the AP PIN Code on
the client device.
 • Pairingfromthewirelessrouter:PresstheWPSbutton
on wireless client, and then perform the WPS connection
process in PIN code mode and enter the Client PIN Code
on the WPS Method > Client PIN Code filed. Check if
the PIN code is correct and then click Start to pair with
wireless client.
NOTES:
• WPSsupportsauthenticationusingOpenSystemandWPA2-
Personal. WPS does not support a wireless network that uses a
Shared Key, WPA-Personal, WPA-Enterprise, WPA2-Enterprise, and
RADIUS encryption method.
• Checkyourwirelessdeviceoritsusermanualforthelocationofthe
WPS button.
• DuringtheWPSprocess,thewirelessrouterscansforanyavailable
WPS devices. If the wireless router does not find any WPS devices, it
switches to idle mode.
• Therouter’spowerLEDindicatorsquicklyflashthreeminutesuntil
the WPS setup is completed.