User Guide

4-11
Novell NetWare Installation
flush_diskreq= 0-FFFF 0 A bit mask to send
occasionally ordered tags
to specific targets. By
default, no targets receive
occasionally ordered tags.
This bit mask is entered in
hex (see Bit Mask Options
on page 4-12).
lun_enable=
1
0-FF 01 A bit mask to enable
scanning for specific
LUNs on all targets. The
default value of 01 causes
the driver to scan LUN 0
only. This enable bit mask
is entered in hex (see Bit
Mask Options on
page 4-12.)
max_tags= 1-128 16 Specifies maximum
number of tagged
commands per device.
multlun_targets= 0-FFFF FFFF A bit mask to enable
LUNs on selected targets.
By default, LUNs on all
targets are enabled. This
bit mask is entered in hex
(see Bit Mask Options on
page 4-12).
slot= 0-xxxx
1
0 Defines a physical slot
number for the host
adapter. If 0 is specified, or
if this option is not
specified, then the driver
loads for all 7800 Family
host adapters.
verbose= yes, no no Displays host adapter
configuration information
at load time.
1
The values can vary and are dependent on the system configuration.
Option Values Default Description