User Guide

6-7
SCO UNIX Installation
Use the Install Package
To load the driver using installpkg, follow these steps:
1
At the UNIX system prompt, type installpkg and press Enter.
The screen then displays these messages:
Confirm
Please insert the floppy disk
:
:
Strike ENTER when ready
or ESC to stop.
2
Insert the 7800 Family Manager Set diskette for SCO UNIX and
press Enter. The screen then displays these messages:
Installation is in progress — do not remove the floppy disk.
The following packages are on this disk:
NAME DESCRIPTION
alad Adaptec 7800 Family Driver for SCO UNIX 3.2v4.2/dxx
alad325 Adaptec 7800 Family Driver for SCO OpenServer 5/dxx
blad Adaptec 7800 U2 Family Driver for SCO UNIX
3.2v4.2/dxx
blad325 Adaptec 7800 U2 Family Driver for SCO OpenServer
5/dxx
Please enter the names of the packages you wish to install, or q to
quit:
3
At this point, type alad or blad (or alad325 or blad325 for SCO
OpenServer 5) and press Enter. The screen then displays this
message and various installation status prompts:
Installing alad
When the driver is done loading, the following appears:
Installed alad
#
The
alad / alad325 driver has now been loaded into the Link Kit
for kernel addition.