User Guide

7-2
Adaptec 7800 Family Manager
Installing the Driver When Installing SCO
UnixWare
To install the adsl20 / adsl or adsb20 / adsb drivers at the same time
you install SCO UnixWare, follow the instructions below. The
procedures are the same for SCO UnixWare 2.0x and 2.1.
1
Insert the Install diskette of the SCO UnixWare package into
the floppy boot drive. Reboot your computer.
Wait for the first SCO UnixWare installation screen and prompt
to appear, then follow the onscreen instructions.
2
When prompted to either Install Host Bus Adapter Drivers or
Continue Installation, first remove the Install diskette, then
select Install Host Bus Adapter Driver and press Enter.
3
Insert the 7800 Family Manager Set diskette for UnixWare 2.x
into the primary floppy drive and press Enter (you cannot load
drivers from a secondary floppy drive).
As the driver loads, a message identifying the installed host
adapter briefly appears on screen. The installation process
determines which device drivers on the diskettes are needed.
4
If you have additional HBA diskettes, insert the next HBA
diskette, select Install Another HBA Diskette, and press
Enter.
If all of your HBA diskettes have been installed, remove the
last HBA diskette, select Continue Installation, and press
Enter.
5
If necessary, enter the DCU (Device Configuration Utility) to
view/change the SCO UnixWare device driver configuration
data.
6
Follow the onscreen instructions to continue with installation.
Refer to the SCO UnixWare documentation and onscreen help
files for help in choosing options.