User manual
3-26
Chapter 3: BIOS setup
Chapter 3
Options for SB HD Azalia.
HD Audio Azalia Device [Enabled]
Allows you to enable or disable the HD Audio controller.
Conguration options: [Disabled] [Enabled]
Azalia Front Panel [HD]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC’97 or
high-denition audio depending on the audio standard that the front panel audio
module supports.
[AC 97] Sets the front panel audio connector (AAFP) mode to legacy AC’97
[HD] Sets the front panel audio connector (AAFP) mode to high denition
audio.
SPDIF Out Type [SPDIF]
[SPDIF] Sets to [SPDIF] for SPDIF audio output.
[HDMI] Sets to [HDMI] for HDMI audio output.
3.5.8 APM
ErP Ready [Disabled]
[Disabled] Disables the Energy Related Products (ErP) Ready function.
[Enabled] Allows BIOS to switch off some power at S5 state to get system ready for
the ErP requirement. When set to [Enabled], power for WOL, WO_USB,
audio and onboard LEDs will be switched off at S5 state.
Restore AC Power Loss [Power Off]
When set to [Power Off], the system goes into off state after an AC power loss. When set
to [Power On], the system will reboot after an AC power loss. When set to [Last State], the
system goes into either off or on state, whatever the system state was before the AC power
loss.
Conguration options: [Power Off] [Power On] [Last State]