User manual
Table Of Contents
- Notices
- Safety information
- Care & Cleaning
- Takeback Services
- 1.1 Welcome!
- 1.2 Package contents
- 1.3 Assembling the monitor base
- 1.4 Connect cables
- 1.5 Monitor introduction
- 2.1 Detaching the base
- 2.2 Adjusting the monitor
- 3.1 OSD (On-Screen Display) menu
- 3.2 Specifications
- 3.3 Troubleshooting (FAQ)
- 3.4 Supported Timing List
3-11
Chapter 3: General Instruction
3.3 Troubleshooting (FAQ)
Problem Possible Solution
Power LED is not ON
• Press the
button to check if the monitor is in the
ON mode.
• Check if the power cord is properly connected to the
monitor and the power outlet.
• Check Power Indicator function in main menu OSD.
Select “ON“ to turn on power LED.
The power LED lights amber and
there is no screen image
• Check if the monitor and the computer are in the
ON mode.
• Make sure the signal cable is properly connected
the monitor and the computer.
• Inspect the signal cable and make sure none of the
pins are bent.
• Connect the computer with another available
monitor to check if the computer is properly working.
Screen image is too light or dark • Adjust the Contrast and Brightness settings via
OSD.
Screen image bounces or a wave
pattern is present in the image
• Make sure the signal cable is properly connected to
the monitor and the computer.
• Move electrical devices that may cause electrical
interference.
Screen image has color defects
(white does not look white)
• Inspect the signal cable and make sure that none of
the pins are bent.
• Perform Reset via OSD.
• Select the appropriate Color Temperature via OSD.
No sound or sound is low • Adjust the volume settings of both your monitor and
computer.
• Make sure the computer sound card driver is
properly installed and activated.