User Manual

ASUS A7S266-VM/U2 Motherboard 2-17
SDRAM CAS Latency [3T]
This item controls the latency between the SDRAM read command and the time
the data actually becomes available.
SDRAM RAS to CAS Delay [4T]
This item controls the latency between the DDR SDRAM active command and the
read/write command.
SDRAM RAS Precharge Time [4T]
This item controls the idle clocks after issuing a precharge command to the DDR
SDRAM.
SDRAM RAS Active Time [7T]
This item controls the number of DDR SDRAM clocks used for DDR SDRAM
parameters.
Graphics Aperture Size [64MB]
This feature allows you to select the size of mapped memory for AGP graphic data.
Configuration options: [4MB] [8MB] [16MB] [32MB] [64MB] [128MB] [256MB]
[512MB]
Onboard VGA Shared Memory Size [32MB]
This field allows you set the onboard VGA shared memory size with the currently
installed memory. Configuration options: [8MB] [16MB] [32MB] [64MB]
Video Memory Cache Mode [UC]
USWC (uncacheable, speculative write combining) is a new cache technology for
the video memory of the processor. It can greatly improve the display speed by
caching the display data. You must set this to UC (uncacheable) if your display
card does not support this feature, otherwise the system may not boot.
Configuration options: [UC] [USWC]
Delayed Transaction [Enabled]
When set to [Enabled], this feature frees the PCI bus when the CPU is accessing
8-bit ISA cards. This process normally consumes about 50-60 PCI clocks without
PCI delayed transaction. Set this field to [Disabled] when using ISA cards that are
not PCI 2.1 compliant. Configuration options: [Enabled] [Disabled]
Onboard PCI IDE Enable [Both]
This field allows you to enable either the primary IDE channel or secondary IDE
channel, or both. You can also set both channels to [Disabled]. Configuration
options: [Both] [Primary] [Secondary] [Disabled]
The SDRAM parameters (items 2~5) become configurable only when you set
the SDRAM Configuration to [User Defined].