User Manual

AAM6030BI User Manual

Figure 20 (Ping test)

4.7.6 Modem Test

The Modem Test is used to check whether your Modem is properly connected to the WAN Network. This

test may take a few seconds to complete. To perform the test, select your connection from the list and press

the Test button. Before running this test, make sure you have a valid DSL link; if the DSL link is not

connected, this test will always fail.

Also the DSLAM must support this feature; not all DSLAMs have F4 and F5 support.

4.8 Status

The Status section allows you to view the Status/Statistics of different connections and interfaces

4.8.1 Network Statistics

Select to view the Statistics of different interfaces - Ethernet/USB/DSL.

4.8.2 Connection Status

Select to view the Status of different connections.

4.8.3 DHCP Clients

Select to view the list of DHCP clients.

4.8.4 Modem Status

Select to view the Status and Statistics of your broadband (DSL) connection.

4.8.5 Product Information

You can display the CPE’s driver and run-time information by going to the Home screen, under the Status

title, click Product Information.