Installation Guide
RAID configuration and driver installationRAID configuration and driver installation
RAID configuration and driver installationRAID configuration and driver installation
RAID configuration and driver installation
3333
3333
33
6. A pop-up message appears, warning you that all existing data on the
hard disk drives will be deleted. Press <Y>.
7. After you have created the RAID 0+1 set, press any key to reboot the
system.
During POST, the FastTrak S150 TX4™ BIOS checks and displays the
disk array information.
8. Use the FDISK utility to format the array as a single hard drive.
9. After you have formatted the arrayed drives, install an operating
system (OS). The OS will treat the RAID 0+1 set as a single drive unit.