User Guide

Chapter 2: Hardware setupChapter 2: Hardware setup

Chapter 2: Hardware setup

2-122-12

2-12

Before you can install a 5.25-inch drive, you should first remove the

front panel assembly (front bezel and front panel cover). The front panel

assembly is attached to the chassis through four

hooked tabshooked tabs

hooked tabs on the

left side and four

hinge-like tabshinge-like tabs

hinge-like tabs on the right side.

To remove the front panel assembly:

1. Pull the lock lever (blue bar) on the

front edge of the chassis outward to

release the front panel assembly.

2.5 Front panel assembly

2.5.12.5.1

2.5.1

Removing the front panel assemblyRemoving the front panel assembly

Removing the front panel assembly

2. Pull and swing the left edge of the front

panel outward.

Lock leverLock lever

Lock lever