User Guide

Chapter 2: Hardware setupChapter 2: Hardware setup

Chapter 2: Hardware setup

2-162-16

2-16

3. When released, pull up the drive bay lock bar. Underneath the lock bar

are two pegs that match the holes on the drive bay. This mechanism

secures the drive to the bay in place of screws.

4. While holding up the drive lock

bar, carefully insert a 5.25-inch

drive into the bay, until the back

of the drive aligns to the rear

edge of the drive cage.

5. Connect the IDE cable to the IDE

connector on the back of the

drive.

6. Connect a 4-pin plug from the

power supply to the power

connector on the back of the

drive.

Due to space constraints inside the chassis, do not insert the drive all

the way at this time. This will allow you enough space to easily connect

the drive cables.

IDE cableIDE cable

IDE cable

Power plugPower plug

Power plug

Drive bay holesDrive bay holes

Drive bay holes

Lock pegsLock pegs

Lock pegs