User guide

Chapter 4: Motherboard information
4-8
2. VGA controller setting (3-pin VGA_SW1)
This jumper allows you to enable or disable the onboard VGA controller. Set to pins 1–2
to activate the VGA feature.
3. LAN controller setting (3-pin LAN_SW1, LAN_SW2)
These jumpers allows you to enable or disable the onboard Intel
®
I210AT Gigabit LAN
controllers. Set to pins 1-2 to activate the Gigabit LAN feature.
4. RAIDcongurationutilityselection(3-pinRAID_SEL1)
This jumper allows you to select the RAID conguration utility for creating disk arrays.
Place the jumper caps over pins 1–2 if you want to use a Third-Party Setup Utility
(default). Otherwise, place the jumper caps to pins 2–3 to use the Intel
®
Rapid Storage
Technology.