User's Manual

ASUS CUSL2-C Black Pearl User’s Manual 39

3. HARDWARE SETUP

Connectors

3. H/W SETUP

16) Wake-On-LAN Connector (3-pin WOL_CON)

This connector connects to a LAN card with a Wake-On-LAN output, such as

the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up

the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that Wake On LAN or PCI Modem is

enabled (see 4.5.1 Power Up Control) and that your system has an ATX power

supply with at least 720mA +5V standby power.

CUSL2-C BP

CUSL2-C BP Wake-On-LAN

Connector

IMPORTANT: Requires an ATX power

supply with at least 720mA +5 volt

standby power

+5 Volt Standby

PME

Ground

WOL_CON

17) Wake-On-Ring Connector (2-pin WOR_CON)

This connector connects to internal modem cards with a Wake-On-Ring output.

The connector powers up the system when a ringup packet or signal is received

through the internal modem card. NOTE: For external modems, Wake-On-Ring

is detected through the COM port.

IMPORTANT: This feature requires that Wake On LAN or PCI Modem is

enabled (see 4.5.1 Power Up Control) and that your system has an ATX power

supply with at least 720mA +5V standby power.

CUSL2-C BP

CUSL2-C BP Wake-On-Ring

Connector

WOR_CON

Ring# Ground