E-Manual

付録
99
For Model P028
Federal Communications Commission Statement
is device complies with FCC Rules Part 15. Operation is subject to the following two conditions:
• isdevicemaynotcauseharmfulinterference.
• isdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesired
operation.
is equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to Part 15 of the Federal Communications Commission (FCC) rules. ese limits are designed to provide
reasonable protection against harmful interference in a residential installation. is equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment causes harmful interference
to radio or television reception, which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by doing one or more of the following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdierentfromthattowhichthereceiveris
connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Changes or modications not expressly approved by the party responsible for compliance could void the
user‘s authority to operate the equipment.
e antenna(s) used for this transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
e country code selection is for non-US model only and is not available to all US model. Per FCC
regulation, all Wi product marketed in US must xed to US operation channels only.
For FCC and IC e-labelling information, please go to Settings > About > Regulatory information.
RF Exposure Information (SAR)
is device meets the government’s requirements for exposure to radio waves. is device is designed and
manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the U.S. Government.
e exposure standard employs a unit of measurement known as the Specic Absorption Rate, or SAR.
e SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions
accepted by the FCC with the EUT transmitting at the specied power level in dierent channels.
e highest SAR value for the device as reported to the FCC is 0.9 W/kg when placed next to the body.
e FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines. SAR information on this device is on le with the
FCC and can be found at www.fcc.gov/general/fcc-id-search-page aer searching on FCC ID: MSQP028.