User Guide
Table Of Contents
- Contents
- Notices
- Safety information
- Care & Cleaning
- Takeback Services
- Product information for EU energy label
- Chapter 1: Product introduction
- 1.1 Welcome!
- 1.2 Package contents
- 1.3 Monitor introduction
- Chapter 2: Setup
- 2.1 Monitor standing positions
- 2.2 Adjusting the monitor
- 2.3 Connecting the cables
- 2.4 Turning on the monitor
- 2.5 Performing wireless projection
- 2.6 Connecting the monitor to the Internet
- 2.7 Updating wireless projection firmware
- 2.8 Announcements
- Chapter 3: General instructions
- 3.1 OSD (On-Screen Display) menu
- 3.2 Specifications summary
- 3.3 Outline dimensions
- 3.4 Troubleshooting (FAQ)
- 3.5 Supported operating modes
2-5ASUS Wireless Portable Monitor MB16A
2.7 Updatingwirelessprojectionrmware
1. Make sure that the monitor connects to the Internet.
2. After the monitor successfully connects to the Internet, new IP address will
be assigned to the monitor and displayed on the upper right corner of the
monitor.
3. Connect your device to the same WiFi network as the monitor.
4. Open the web browser on your device and go to the IP address of the monitor
(displayed on the upper right corner of the monitor). If there's newer version
of rmware available, click OK to start the update.
5. Once conrmed, the monitor will start the process and reboot itself when
nished.