User Manual

iv. Run the update tool via the following SSH command

“sudo ./AP_Peripheral_Installer_v0.1”

• The update will run, you will see the output “Complete” when the

update is complete.

v. After, via SSH check the firmware version of the Camera SoM:

• To check the Camera SoM firmware version “lsusb -d 045e:066f -v”

• The output should look like the below for the Camera SoM, please

confirm that the “bcdDevice” section has the version number “3.00”. If

the version shows “1.00” then the firmware fix was not successful.

Please reattempt the steps above and try again.

•

• Note: If the SoM shows version “0.08” then you are using Private

Preview hardware that is not supported by this firmware update and

tool.

Updating the Azure Percept DK’s Container for the Audio Accessory SoM:

• The container is located in Microsoft Container Registry here:

mcr.microsoft.com/azureedgedevices/azureearspeechclientmodule:1.0.4-noauth

• To update the container on the Azure Percept DK, please follow the steps here:

https://learn.microsoft.com/en-us/azure/iot-edge/how-to-deploy-modules-

portal?view=iotedge-1.4

o The update is applied to a container on IoT Edge on the Azure Percept DK

o The update method above is via the Azure Portal

▪ An alternative method is to update the container via VS Code. Directions on

how to do so start at Step 3 here: https://learn.microsoft.com/en-

us/azure/azure-percept/create-people-counting-solution-with-azure-percept-

devkit-vision

Updating the Azure Percept DK’s Container for the Vision Accessory SoM: