Installation Manual

Step 5. Close the CPU Retention
Hold both the lever and the CPU retention with both hands, and firmly lower the
CPU retention to fit into the screw latch as shown below, and then secure the lever.
The CPU cap will pop out once the lever is secured in place. Then remove the CPU
cover, and you now have your CPU properly installed.
Note: Do not press on the CPU cap when holding the CPU retention. This will stop the
CPU cap from popping out and the CPU may be damaged.
1.
U
se
both hands
to
hold the lever and the
CPU retention.
3.
Secure the lever back in the lock.
4.
The CPU cover will
pop out
once the lever
is secured.
2.
Lower the CPU retention and fit it into
the screw latch.