Manual

Installing Fusion Block System accessory 1
Installing Fusion Block System accessory
Install your watercooling system to the motherboard using the bundled accessories
to obtain the best thermal solution.
Package contents
1
2
For watercooling system with 3/8” ID tubes
1. Firmlypressatubeclipandtthetubeintotheclip.
2. Press the clip and connect the tube to the waterblock. When done, release
the clip to tighten the two together.
3. Repeat Step 1 and 2 for another tube. Make sure that both tubes are well
connectedtopreventleak,andthenllthecoolantintothereservoir.
3/8” ID tubes x 2 1/2”to3/8”IDttingsx2 10mmto3/8”IDttingsx2
1/2” ID tube clips x 2tube clips x 2 3/8” ID tube clips x 6