Service manual

7 - 30 Genie GS-1530 & Genie GS-1930 Part No. 39528
Service Manual - First Edition
Section 7 - Repair Procedures
SCISSOR COMPONENTS
13 Use a soft metal drift to remove the number 4
pivot pin (index #4) at the steer end. Remove
the number 4 inner arm (index #3) from the
machine.
Bodily injury hazard. The number 4
inner arm (index #3) may become
unbalanced and fall if not properly
supported when it is removed from
the machine.
14 Attach a lifting strap from an overhead crane to
the number 3 outer arm (index #18).
15 Remove the external snap rings from the
number 3 center pivot pin (index #5).
16 Use a soft metal drift to remove the number 3
center pivot pin (index #5).
17 Remove the external snap rings from the
number 3 pivot pin (index #19) from the non-
steer end of the machine.
18 Use a soft metal drift to remove the number 3
pivot pin (index #19) from the non-steer end of
the machine. Remove the number 3 outer arm
(index #18) from the machine.
Bodily injury hazard. The number
3 outer arm (index #18) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
19 Attach a lifting strap from an overhead crane to
lug on the rod end of the lift cylinder.
20 Remove the pin retaining fasteners from the
cylinder rod-end pivot pin (index #6). Use a soft
metal drift to remove the pin.
Bodily injury hazard. The cylinder
may fall if not properly supported
when the pin is removed.
21 Lower the cylinder onto the number 1 center
pivot pin (index #12).
22 Remove the cables from the number 3 inner
arm (index #7) and lay them off to the side.
23 Attach a lifting strap from an overhead crane to
number 3 inner arm (index #7).
24 Remove the external snap rings from the
number 3 pivot pin at the steer end (index #8).
25 Use a soft metal drift to remove the number 3
pivot pin (index #8). Remove the number 3
inner arm (index #7) from the machine.
Bodily injury hazard. The number
3 inner arm (index #7) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
26 Remove the cable clamps from the lower cable
tray. Lay the cables off to the side of the
machine.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
27 Attach a strap from an overhead crane to the
number 2 outer arm (index #20).
28 Remove the mounting fasteners from the lower
cable tray supports.