User Manual

68 Single Board Computer
Flow Control
Flow control can prevent data loss from buer overow. When sending
data, if the receiving buers are full, a “stop” signal can be sent to stop
the data ow. Once the buers are empty, a “start” signal can be sent
to re-start the ow. Hardware ow control uses two wires to send start/
stop signals.
Conguration options: [None] [Hardware RTS/CTS]
VT-UTF8 Comb
o Key Support
Allows you to enable the VT-UTF8 Combo Key Support for ANSI/VT100
terminals.
Conguration options: [Disabled] [Enabled]
Recorder Mo
de
With this mode enabled only text will be sent. This is to capture
Terminal data.
Conguration options: [Disabled] [Enabled]
Resolution 100x31
Allows y
ou to enable or disable extended terminal resolution.
Conguration options: [Disabled] [Enabled]
Putty Ke
yPad
This allows you to select the FunctionKey and Keypad on Putty.
Conguration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN]
[VT400]
COM5 (Pci Bus0, Dev0, Func0) (on selected models)
Console Redirection
Allows you to enable or disable the console redirection feature.
Conguration options: [Disabled] [Enabled]