User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 CPU Configuration
- 4.4.4 Graphics Configuration
- 4.4.5 Watchdog Timer
- 4.4.6 AMT Configuration (on selected models)
- 4.4.7 Super IO Configuration
- 4.4.8 Serial Console Redirection
- 4.4.9 SATA configuration
- 4.4.10 VMD setup menu
- 4.4.11 Network Stack Configuration
- 4.4.12 USB Configuration
- 4.4.13 NVMe Configuration
- 4.4.14 Onboard Devices Configuration
- 4.4.15 APM Configuration
- 4.4.16 EZ-Flash
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 MEBx menu
- 4.10 Updating your BIOS
- Appendix
Single Board Computer
69
SATA Controller(s)
Allows you to enable or disable the SATA Controller.
Conguration options: [Disabled] [Enabled]
NOTE: The following items appear only when SATA Controller(s) is set
to [Enabled].
SATA Mode Selection
Allows you to set the SATA mode.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use
the AHCI (Advanced Host Controller Interface). AHCI allows the
onboard storage driver to enable advanced Serial ATA features
that increases storage performance on random workloads by
allowing the drive to internally optimize the order of commands.
The following item appears only when SATA Mode Selection is
set to [Intel RST
4.4.9 SATA conguration
The items in this menu allow you to congure SATA device options.
While entering Setup, the BIOS automatically detects the presence of SATA
devices. The SATA Port items show [Empty] if no SATA device is installed to
the corresponding SATA port.