User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 CPU Configuration
- 4.4.4 Graphics Configuration
- 4.4.5 Watchdog Timer
- 4.4.6 AMT Configuration (on selected models)
- 4.4.7 Super IO Configuration
- 4.4.8 Serial Console Redirection
- 4.4.9 SATA configuration
- 4.4.10 VMD setup menu
- 4.4.11 Network Stack Configuration
- 4.4.12 USB Configuration
- 4.4.13 NVMe Configuration
- 4.4.14 Onboard Devices Configuration
- 4.4.15 APM Configuration
- 4.4.16 EZ-Flash
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 MEBx menu
- 4.10 Updating your BIOS
- Appendix
Single Board Computer
57
4.4.1 PCH-FW Configuration
The items in this menu allow you to configure Management Engine
Technology Parameters.
TPM Device Selection
This item allows you to select the TPM device.
[dTPM] Discrete TPM
[PTT] Intel Platform Trust Technology firmware TPM
NOTE:
• When [dTPM] is selected, PTT (firmware TPM) will be disabled,
and the TPM device connected to the SPI TPM connector on the
motherboard will be enabled. If no TPM device is connected, the
TPM feature will be disabled.
• When [PTT] is selected, PTT (firmware TPM) is enabled.
WARNING! When [dTPM] is selected, PTT (firmware TPM) will be
disabled and all data saved on it will be lost.