User's Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 Platform Misc Configuration
- 4.4.4 CPU Configuration
- 4.4.5 System Agent (SA) Configuration
- 4.4.6 PCH-IO Configuration
- 4.4.7 PCH Storage Configuration
- 4.4.8 Onboard Devices Configuration
- 4.4.9 ACPI Settings
- 4.4.10 APM Configuration
- 4.4.11 NCT6116D Super IO Configuration
- 4.4.12 NCT6116D HW Monitor
- 4.4.13 Serial Port Console Redirection
- 4.4.14 USB Configuration
- 4.4.15 Network Stack Configuration
- 4.4.16 NVMe Configuration
- 4.4.17 SDIO Configuration
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
Single Board Computer
45
3.6 Installing the wireless card
1. Remove the M.2 stand screw.
2. Align and insert the wireless card into its slot on the motherboard, then
gently push down the wireless card on top of the screw hole and fasten
it using the previously removed stand screw.
3. (optional) Connect the antennas to your wireless card.
NOTE:
• Connecting antennas to your wireless card may strengthen the
wireless signal.
• A soft clicking sound indicates that the antenna has been securely
attached on the wireless card.
• The antennas are purchased separately.