User's Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 Platform Misc Configuration
- 4.4.4 CPU Configuration
- 4.4.5 System Agent (SA) Configuration
- 4.4.6 PCH-IO Configuration
- 4.4.7 PCH Storage Configuration
- 4.4.8 Onboard Devices Configuration
- 4.4.9 ACPI Settings
- 4.4.10 APM Configuration
- 4.4.11 NCT6116D Super IO Configuration
- 4.4.12 NCT6116D HW Monitor
- 4.4.13 Serial Port Console Redirection
- 4.4.14 USB Configuration
- 4.4.15 Network Stack Configuration
- 4.4.16 NVMe Configuration
- 4.4.17 SDIO Configuration
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
Single Board Computer
77
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates
the beginning.) The standard setting is 1 stop bit. Communication with
slow devices may require more than 1 stop bit.
Conguration options: [1] [2]
Flow Control
Flow control can prevent data loss from buer overow. When sending
data, if the receiving buers are full, a “stop” signal can be sent to stop
the data ow. Once the buers are empty, a “start” signal can be sent
to re-start the ow. Hardware ow control uses two wires to send start/
stop signals.
Conguration options: [None] [Hardware RTS/CTS]
VT-UTF8 Combo Key Support
Allows you to enable the VT-UTF8 Combo Key Support for ANSI/VT100
terminals.
Conguration options: [Disabled] [Enabled]
Recorder Mode
With this mode enabled only text will be sent. This is to capture
Terminal data.
Conguration options: [Disabled] [Enabled]
Resolution 100x31
Allows you to enable or disable extended terminal resolution.
Conguration options: [Disabled] [Enabled]
Putty Keypad
This allows you to select the FunctionKey and Keypad on Putty.
Conguration options: [VT100] [Intel Linux] [XTERMR6] [SCO] [ESCN]
[VT400]
Legacy Console Redirection Settings
Redirection COM Port
Allows you to select a COM port to display redirection of Legacy OS and
Legacy OPROM Messages.
Conguration options: [COM1] [COM2] [COM3] [COM4] [COM5] [COM6]