User's Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 Platform Misc Configuration
- 4.4.4 CPU Configuration
- 4.4.5 System Agent (SA) Configuration
- 4.4.6 PCH-IO Configuration
- 4.4.7 PCH Storage Configuration
- 4.4.8 Onboard Devices Configuration
- 4.4.9 ACPI Settings
- 4.4.10 APM Configuration
- 4.4.11 NCT6116D Super IO Configuration
- 4.4.12 NCT6116D HW Monitor
- 4.4.13 Serial Port Console Redirection
- 4.4.14 USB Configuration
- 4.4.15 Network Stack Configuration
- 4.4.16 NVMe Configuration
- 4.4.17 SDIO Configuration
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
Single Board Computer
93
WARNING
• This function can support devices such as a USB ash disk with FAT
32/16 format and single partition only.
• DO NOT shut down or reset the system while updating the BIOS to
prevent system boot failure!
IMPORTANT! Ensure to load the BIOS default settings to ensure system
compatibility and stability. Press <F5> and select Yes to load the BIOS
default settings.
4.8.3 BUPDATER utility
NOTE: The succeeding BIOS screens are for reference only. The actual
BIOS screen displays may not be the same as shown.
The BUPDATER utility allows you to update the BIOS le in DOS environment
using a bootable USB ash disk drive with the updated BIOS le.
Updating the BIOS le
To update the BIOS le using the BUPDATER utility:
1. Visit the ASUS website at www.asus.com and download the latest BIOS
le for the motherboard. Save the BIOS le to a bootable USB ash disk
drive.
2. Download the BUPDATER utility (BUPDATER.exe) from the ASUS
support website at support.asus.com to the bootable USB ash disk
drive you created earlier.
3. Boot the system in DOS mode, then at the prompt, type:
BUPDATER /i[lename].CAP
where [lename] is the latest or the original BIOS le on the bootable
USB ash disk drive, then press <Enter>.
A:\>BUPDATER /i[le name]CAP