User's Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 Platform Misc Configuration
- 4.4.4 CPU Configuration
- 4.4.5 System Agent (SA) Configuration
- 4.4.6 PCH-IO Configuration
- 4.4.7 PCH Storage Configuration
- 4.4.8 Onboard Devices Configuration
- 4.4.9 ACPI Settings
- 4.4.10 APM Configuration
- 4.4.11 NCT6116D Super IO Configuration
- 4.4.12 NCT6116D HW Monitor
- 4.4.13 Serial Port Console Redirection
- 4.4.14 USB Configuration
- 4.4.15 Network Stack Configuration
- 4.4.16 NVMe Configuration
- 4.4.17 SDIO Configuration
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
Single Board Computer
31
16. Serial Port connector
The Serial (COM) Port connector allows you to connect a serial cable.
Connect the 2x5p connector from the serial cable to this connector,
then align and secure the DB-9 connector to the cut-out on the system
chassis panel.
Connector type
BOX header 2x5p, K10, 2.0mm pitch
NOTE:
• The serial cable is purchased separately.
• COM1 and COM2 support RS-232/422/485.
• COM 3, COM4, COM5, and COM6 support RS-232.