User's Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 Platform Misc Configuration
- 4.4.4 CPU Configuration
- 4.4.5 System Agent (SA) Configuration
- 4.4.6 PCH-IO Configuration
- 4.4.7 PCH Storage Configuration
- 4.4.8 Onboard Devices Configuration
- 4.4.9 ACPI Settings
- 4.4.10 APM Configuration
- 4.4.11 NCT6116D Super IO Configuration
- 4.4.12 NCT6116D HW Monitor
- 4.4.13 Serial Port Console Redirection
- 4.4.14 USB Configuration
- 4.4.15 Network Stack Configuration
- 4.4.16 NVMe Configuration
- 4.4.17 SDIO Configuration
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
46
Single Board Computer
3.7 Installing an M.2 SSD
1. (optional) Replace the stando if it has been removed.
NOTE: We recommend using a PH1/sleeve screwdriver with a torque of
2.0±0.2kgf-cm when tightening the stando.
2. Align and insert the M.2 SSD into its slot inside the Single Board
Computer, then gently push down the M.2 SSD on top of the stando
and fasten it using a screw.
NOTE: We recommend using a PH1 screwdriver with a torque of
2.0±0.2kgf-cm when tightening the screw.