User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 CPU Configuration
- 4.4.4 Graphics Configuration
- 4.4.5 Watchdog Timer
- 4.4.6 AMT Configuration (on selected models)
- 4.4.7 Super IO Configuration
- 4.4.8 Serial Console Redirection
- 4.4.9 SATA configuration
- 4.4.10 VMD setup menu
- 4.4.11 Network Stack Configuration
- 4.4.12 USB Configuration
- 4.4.13 NVMe Configuration
- 4.4.14 Onboard Devices Configuration
- 4.4.15 APM Configuration
- 4.4.16 EZ-Flash
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 MEBx menu
- 4.10 Updating your BIOS
- Appendix
46
Single Board Computer
3.7 Installing a heatsink
1. Place the heatsink with its fins faced down on a flat surface.
2. Place the motherboard over the heatsink so that the five (5) screw
holes on the motherboard are aligned to the five (5) standoffs on the
heatsink as shown below.
3. Secure the motherboard to the heatsink using the five (5) spring screws
bundled with the heatsink in the sequence shown below.