User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 Platform Misc Configuration
- 4.4.4 CPU Configuration
- 4.4.5 PCH-IO Configuration
- 4.4.6 PCH Storage Configuration
- 4.4.7 Onboard Devices Configuration
- 4.4.8 ACPI Settings
- 4.4.9 APM Configuration
- 4.4.10 NCT6116D Super IO Configuration
- 4.4.11 NCT6116D HW Monitor
- 4.4.12 Serial Port Console Redirection
- 4.4.13 USB Configuration
- 4.4.14 Network Stack Configuration
- 4.4.15 NVMe Configuration
- 4.4.16 LFP Configuration
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Appendix
48
Single Board Computer
3.8 Installing a heat spreader
1. Place the heat spreader with its copper pad and thermal interface
material facing up on a at surface.
2. Remove the plastic protective lm from the copper pad and thermal
interface material on the heat spreader, if there is one.
3. Orient the motherboard so that the CPU and chipset on its backside are
in direct contact with the copper pad on the heat spreader, and the ve
(5) screw holes on the motherboard are aligned to the ve (5) standos
on the heat spreader.
Copper pad & thermal
interface material
Screw hole
Stando