User's Manual

Coating Notice
IMPORTANT!Toprovideelectricalinsulationand
maintain electrical safety, a coating is applied to
insulate the device except on the areas where the I/
O ports are located.
Federal Communications Commission
Statement
ThisdevicecomplieswithPart15oftheFCCRules.
Operation is subject to the following two conditions:
• Thisdevicemaynotcauseharmfulinterference,
and
• Thisdevicemustacceptanyinterferencereceived
including interference that may cause undesired
operation.
Thisequipmenthasbeentestedandfoundtocomply
withthelimitsforaClassBdigitaldevice,pursuanttoPart
15oftheFCCRules.Theselimitsaredesignedtoprovide
reasonable protection against harmful interference in
aresidentialinstallation.Thisequipmentgenerates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with manufacturer’s
instructions, may cause harmful interference to radio
communications.However,thereisnoguaranteethat
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipment
and receiver.
• Connecttheequipmenttoanoutletonacircuit
different from that to which the receiver is
connected.