User's Manual

Coating Notice
IMPORTANT! To provide electrical insulation and
maintain electrical safety, a coating is applied to
insulatethedeviceexceptontheareaswheretheI/
O ports are located.
Federal Communications Commission
Statement
ThisdevicecomplieswithPart15oftheFCCRules.
Operation is subject to the following two conditions:
• Thisdevicemaynotcauseharmfulinterference,
and
• Thisdevicemustacceptanyinterferencereceived
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
withthelimitsforaClassBdigitaldevice,pursuanttoPart
15oftheFCCRules.Theselimitsaredesignedtoprovide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installedandusedinaccordancewithmanufacturer’s
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interferencewillnotoccurinaparticularinstallation.If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipment
and receiver.
• Connecttheequipmenttoanoutletonacircuit
different from that to which the receiver is
connected.