Specifications

ASUS CROSSBLADE RANGER
3-11
Chapter 3
address/command drive strength [Auto]
Conguration options: [Auto] [1.00x] [1.25x] [1.50x] [2.00x]
MEMCLK drive strength [Auto]
Conguration options: [Auto] [1.00x] [1.25x] [1.50x] [2.00x]
Data drive strength [Auto]
Conguration options: [Auto] [0.75x] [1.00x] [1.25x] [1.50x]
DQS drive strength [Auto]
Conguration options: [Auto] [0.75x] [1.00x] [1.25x] [1.50x]
Processor on-die termination [Auto]
Conguration options: [Auto] [240 ohms +/- 20%] [120 ohms +/- 20%]
[80 ohms +/- 20%] [60 ohms +/- 20%]
CKE setup time [Auto]
Conguration options: [Auto] [1/2 MEMCLK DELAY] [1 MEMCLK DELAY]
CKE fine delay [Auto]
Conguration options: [Auto] [0]
CS/ODT setup time [Auto]
Conguration options: [Auto] [1/2 MEMCLK DELAY] [1 MEMCLK DELAY]
CS/ODT fine delay [Auto]
Conguration options: [Auto] [0]
address/command setup time [Auto]
Conguration options: [Auto] [1/2 MEMCLK DELAY] [1 MEMCLK DELAY]
address/command fine delay [Auto]
Conguration options: [Auto] [0]
GPU.DIMM Post
Automatically detects and displays the information about the devices or memory installed on
the PCIe and DIMM slots. The eld shows N/A if there are no devices installed on the slots.
DIGI+ Power Control
CPU Load Line Calibration [Auto]
Load Line is dened by AMD
®
specication and affects CPU power voltage. The CPU
working voltage decreases proportionally to CPU loading. Higher Load Line calibration
could get higher voltage and good overclocking performance, but increases the CPU
and VRM thermal conditions. This item allows you to adjust the voltage range from the
following percentages to boost the system performance: 0% (Regular), 20% (Medium),
40% (High) and 100% (Extreme). Conguration options: [Auto] [Regular] [Medium]
[High] [Extreme]
The actual performance boost may vary depending on your CPU specication.
DO NOT remove the thermal module. The thermal conditions should be monitored.