User manual

P
C
M
-3900 PC/104 IDE RAID Module
12
Figure 5.1 Firmware Upgrade Jumper setting
# Please upgrade your F/W as steps as following,
Step 1. Insert your Firmware Upgrade Disk and boot your system from Floppy Drive.
Step 2. Execute the DOS command as following,
A:\> (1) (2) (3) (For example: FLASH103.EXE 0 FIRMWARE.BIN)
(1) <= FLASH XXX.EXE (File name of Firmware Upgrade Utility)
(2) <= Parameter description : 0,1,2,3 present PC/104 IDE RAID Module position
0 : IDE Channel 1, Master;
1 : IDE Channel 1, Slave;
2 : IDE Channel 2, Master;
3 : IDE Channel 2, Slave
(3) <= XX-XX-XX.BIN (File name of New Firmware Code)
Step 3. Follow the steps show on the PC screen.
Step 4. After completion, set the Jumper or Switch back to original setting respectively
Step5. Restart your system
5.2 Where To Get New Firmware & Upgrade Utility
You may download New Firmware Code and Firmware Upgrade Utility via Internet at http://www.Advantech.com.tw
or contact ADVANTECH’s
agents.