User’s Manual

5
ご注意
イク
使用済みのーター、PC等の電子機器は、境に悪影響をる有害物質含ま
てお通常のて廃棄するとはできません。リサルによ使用済みの製品に使
用されている金属部チック部品ンポは粉砕されしい製品に再使用され
ますそのコンや部品、質も正処理される有害物質の拡
となりすることにがります
ASUSは各国の環等を満たル従事者の作業の安全を図
境保護に関する厳しい基準を設ておますASUSのルに対る姿勢は、
して す。
REACH
Complying with the REACH (Registration, Evaluation, Authorisation, and Restriction
of Chemicals) regulatory framework, we published the chemical substances in our
products at ASUS REACH website at http://csr.asus.com/english/REACH.htm
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference; and
This device must accept any interference received including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with manufacturers instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o󱐯 and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit di󱐯erent from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the graphics card is
required to assure compliance with FCC regulations. Changes or modications to
this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate this equipment.
ムバーに付いの警
警告: バーの交換は正行わない破裂の原因ーは製
造元が指定すの、たはそれに相当すものご使用ださい。ー廃
棄の際は、製造元の指示に従