User's Manual

7
1.3 Your wireless router
Power LED
O: No power.
On: Device is ready.
Flashing slow: Rescue mode.
WiFi LED
O: No WiFi signal.
On: Wireless system is ready.
Flashing: Transmitting or receiving data via wireless connection.
LAN (Internet) LED
O: No power or no physical connection.
On: Has physical connection to a local area network (LAN).
DSL / WAN LED
Red: No IP or no physical connection.
On: Has physical connection to a wide area network (WAN).
Aura LEDs / WPS / WiFi combo button
Press the button to change the Aura lighting effects.
Press the button about 2 seconds to turn on/off the LED, Aura lighting, WPS and WiFi.
Aura LEDs
The Aura LEDs light up when the Aura LEDs button is turned on.
Reset button
This button resets or restores the system to its factory default settings.
DSL port
Connect to a splitter or to a telephone outlet via an RJ-11 cable.
USB 3.1 Gen 1 ports
Insert a USB 3.1 Gen 1 device such as a USB hard disk or a USB flash drive into this port.
Insert your iPad’s USB cable into this port to charge your iPad.
LAN 1~4 ports
Connect network cables into these ports to establish LAN connection.